Installation of Accessories

Support leg for supporting the table extension (see figure H)

To stabilise the saw stand when machining long and heavy workpieces, you can support the table extension (2) with a support leg (13).
You can fasten the support leg (13) either left or right of the saw stand.

• Release the locking knob (3) and pull the table extension (2) that you want to be supported slightly out.
• Push the screw head of the support leg (13) into the lower groove of the table extension (2).
• Turn the support leg (13) firmly.
• Screw the height adjustment of the support leg (13) in or out until the saw stand is level again.

Transport wheels and stop for quickly changing the operation site (see figures I1−I2)

The transport wheels (12) allow you to transport the saw stand to another operation site, without having to remove the stationary saw installed on it.
You can fasten the transport wheels (12) either left or right of the saw stand.

• Use the fastening set (20) for installation.
• Place the saw stand on the floor with folded legs up.
• Screw the transport wheels to the saw stand at the required place using the four screws and nuts.
  Use the supplied hex key (14) for this.
• Rotate the saw stand into the working position.
• On the side of the saw stand to which the transport wheels are fastened, release the locking knob (3) and pull the table extension (2) slightly out.
• Push the transport stop (11) into the upper groove of the saw stand and move the transport stop up to the holder set (4).
• Tighten the hexagon screw in the stop with the supplied socket spanner (14).

The holder set with installed power tool can now no longer slip during transport.