Preparing the workpiece support

• Place your workpiece on the saw table for the power tool.
• Release the locking knob (5) and adjust the height of the roller support (7) so that your workpiece is straight.
• Re-tighten this locking knob.

The length stop (8) can be used for easily sawing workpieces of the same length.

• Pull the length stop (8) up until it engages.
• Position the workpiece support (1) at the required distance from the saw blade of the power tool.
• To insert the length stop (8), tilt the length stop in and press it fully down.

The saw stand can be extended on both sides.

• To stabilise the saw stand when machining long and heavy workpieces, you can support the table extension (2) with a support leg (13).
• Place your long workpiece on the saw table for the power tool.
• If necessary, loosen the corresponding locking knob (3) and pull the table extension (2) outwards until it reaches the required length.
• Re-tighten this locking knob.