Preparing the Saw Stand

Preparing holder sets (see figures C1–C4)

• To unlock the holder sets (4), press the buttons (16) and open the levers (17) respectively.
• Measure the distance x between the assembly holes on your power tool.
• Position the holder sets (4) in the centre of the saw stand and at the appropriate distance x from each other.
• Close each lever (17) again. This allows the holder sets to be firmly positioned on the saw stand.

Setting up the saw stand (see figure D)

• Bring the power tool into the transport position. Information about the transport position can be found in the operating instructions for the corresponding power tool.
• Position the movable nuts (18) in the holder sets so that they match the assembly holes on the power tool.
• Screw using the supplied socket spanner (14) holder set and power tool with the hexagon screws and washers from the fastening set (19).