Start-up

Products that are only sold in AUS and NZ: Use a residual current device (RCD) with a nominal residual current of 30 mA or less.

Pay attention to the mains voltage! The voltage of the power source must match the voltage specified on the rating plate of the power tool. Power tools marked with 230 V can also be operated with 220 V.

Always tighten the locking knob (21) and the clamping lever (41) firmly before sawing. Otherwise the saw blade can become wedged in the workpiece.

To switch on the power tool, first slide the lock-off button (7) to the middle and then press and hold the on/off switch (8).

Note: For safety reasons, the on/off switch (8) cannot be locked; it must remain pressed during the entire operation.

To switch off, release the on/off switch (8).

The electronic starting current limitation feature restricts the power of the power tool when it is switched on and enables operation using a 16 A fuse.

Note: If the power tool runs at full speed immediately after being switched on, this means that the starting current limitation has failed. The power tool must be sent to the after-sales service without delay.

Start-up

Switching on (see figure L)

Switching off

Starting current limitation