Technical Data
Line laser | GLL 80-33 G |
---|---|
Article number | 3 601 K65 5.. |
Working range (radius)A) | |
| 30 m |
| 5–80 m |
Levelling accuracyB)C)D) | ±0.3 mm/m |
Self-levelling range | ±4° |
Levelling time | < 4 s |
Operating temperature | –10 °C to +40 °C |
Storage temperature (without lithium-ion battery pack) | –20 °C to +70 °C |
Max. altitude | 2000 m |
Relative air humidity max. | 90% |
Pollution degree according to IEC 61010-1 | 2E) |
Laser class | 2 |
Laser type | < 10 mW, 500−540 nm |
C₆ | 10 |
Divergence | 50 × 10 mrad (full angle) |
Shortest pulse duration | 1/10000 s |
Pulse frequency | 10 kHz |
Compatible laser receiver | LR 7 |
Tripod mount | 1/4", 5/8" |
Energy supply | |
| 3.7 V |
| 4 × 1.5 V LR6 (AA) |
Operating time with 3 laser lines | |
| 5 h |
| 5 h |
WeightF) | 0.93 kg |
Dimensions (length × width × height) | 144 × 89 × 139 mm |
Protection rating | IP65 |
Lithium-ion battery pack (accessory) | BA 3.7V 3.0Ah XL |
Article number | 1 600 A03 1FZ |
Charging connection | USB Type‑C® |
Recommended USB Type‑C® cable | 1 600 A03 4XE |
Rated voltage | 3.7 V |
Capacity | 3.0 Ah |
Recommended ambient temperature during charging | +10 °C to +35 °C |
Permitted ambient temperature during storage | –10 °C to +45 °C |
Power supply | |
Output voltage | 5.0 V |
Minimum output current | 2 A |
- A)
The working range may be reduced by unfavourable environmental conditions (e.g. direct sunlight).
- B)
Applies to the four horizontal intersection points
- C)
The values stated presuppose normal to favourable environmental conditions (e.g. no vibration, no fog, no smoke, no direct sunlight). Extreme fluctuations in temperature can cause deviations in accuracy.
- D)
An additional deviation of ±0.1 mm/m must be taken into account when at maximum self-levelling range.
- E)
Only non-conductive deposits occur, whereby occasional temporary conductivity caused by condensation is expected.
- F)
Weight without lithium-ion battery pack/battery adapter/batteries
The serial number (12) on the type plate is used to clearly identify your measuring tool.