Start-Up

Before carrying out any work on the power tool (e.g. maintenance, tool change etc.), remove the battery from the power tool. There is risk of injury from unintentionally pressing the on/off switch.

Before the power tool can be switched on, the base plate (34) must be locked firmly in place by the clamping screw (33) and the lock washer (32).

Before switching on, check whether the automatic reset function on the motor unit is working correctly. Push the router exit against the edge of a table, for instance, until the side milling cutter is visible. When the pressure is released, the side milling cutter must be fully withdrawn into the base plate.

To switch on the power tool, push the on/off switch (2) forward and push it forwards and down to lock it.

To switch off the power tool, push the on/off switch (2) backwards so that it jumps back into the off position.

The restart protection feature prevents the power tool from uncontrolled starting after the power supply to it has been interrupted.

To restart the tool, set the on/off switch (2) to the off position and then switch the power tool on again.

The electronic soft start limits the torque when the power tool is switched on and increases the service life of the motor.