Transport (see figure N)

You must fold the base unit together for transport.

• Slide the table extensions (5) in fully and slide the workpiece supports (12)and length stops (11) downwards fully.
• Open the locking mechanism (9).
• To release the lock bolts (20), gently push the saw stand downwards by the handle (6).
• Open the locking mechanism (3). This retracts the lock bolts which lock the wheels.
• Place one foot on the foot support (14) and pull the handle (6) upwards with both hands until the lock bolts can engage again on the other side of the stop plates (21).
• Close the locking mechanism (3).