Dust extraction system with Saugfix

For dust extraction, the Saugfix is required. When drilling, the Saugfix retracts so that the Saugfix head is always close to the surface at the drill hole.

• Press the button for depth stop adjustment (12) and remove the depth stop (13). Press the button (12) again and insert the Saugfix into the auxiliary handle (14) from the front.
• Connect an extraction hose (diameter 19 mm) to the suction opening (22) of the Saugfix.

The dust extractor must be suitable for the material being worked.

When extracting dust that is dry, especially detrimental to health or carcinogenic, use a special dust extractor.

You can also set the required drilling depth X when the Saugfix is fitted.

• Push the SDS plus application tool into the SDS plus tool holder  (3) as far as it will go. Otherwise, the movability of the SDS plus drilling tool can lead to incorrect adjustment of the drilling depth.
• Loosen the wing bolt (26) on the Saugfix.
• Without switching it on, press the power tool firmly against the surface you wish to drill. The SDS plus application tool must be touching the surface.
• Slide the guide tube (27) of the Saugfix into its holder so that the head of the Saugfix rests on the surface that is to be drilled. Do not slide the guide tube (27) further than necessary over the telescopic tube (25), so that as much as possible of the scale remains visible on the telescopic tube (25).
• Retighten the wing bolt (26). Loosen the clamping screw (23) on the Saugfix depth stop.
• Slide the depth stop (24) onto the telescopic tube (25) so that the distance X shown in the illustration matches your required drilling depth.
• Tighten the clamping screw (23) in this position.