User Interface (see figure B)

The user interface (9) is used to select the working mode and to indicate the status of the power tool.

Status indications

Status indicator for power tool (20)

Paint

Meaning

Solution

Green

Power tool is switched on and ready to use.

–

Yellow

There is a problem that requires your attention: Critical temperature, battery is almost empty or service is due.

  • Leave the power tool to cool down.
  • Replace or charge the battery.
  • Have maintenance performed.

Red

The power tool is not ready for use.

Reason: Power tool has overheated, battery is empty or mechanical fault.

  • Leave the power tool to cool down.
  • Replace or charge the battery.
  • Have maintenance performed.

Flashing red

  • The second switch was pressed too early.
  • The second switch was not pressed within five seconds; the tool switches off automatically.
  • The switches were pressed in the wrong order (e.g. the trigger was pressed before the tool had switched to contact actuation mode)
  • Wait a short time until the status indicator display lights up green.
  • The power tool is ready for use again.
  • Perform the discharging procedure again, observing the correct order of pressing when doing so, or change the actuation mode via the user interface.

Battery charge indicator (21)

Symbol

Paint

State of charge

–

–

20–100%

Yellow

1–20%

Red

0–1%

Maintenance indicator

Symbol

Paint

Meaning

Solution

Yellow

"Low" level routine service is due.

Contact customer service.

Yellow

"High" level routine service is due.

Contact customer service.

Press the reset button (24) to reset the maintenance counter once the tool has been serviced.