Changing the Tool

The dust protection cap (1) largely prevents the penetration of drilling dust into the tool holder during operation. When inserting the tool, make sure that the dust protection cap (1) does not become damaged.

Replace a damaged dust protection cap immediately. It is recommended that you have use an after-sales service for this.

Inserting the Application Tool (see figure A)

With the SDS max tool holder, you can change the application tool simply and easily without additional aids.

Clean and lightly grease the shank of the application tool.
Push the locking sleeve (2) back and insert the application tool by turning it into the tool holder. Release the locking sleeve (2) to lock the application tool.
Check that it is locked by pulling on the tool.

Removing the application tool (see figure B)

Push the locking sleeve (2) back and remove the application tool.