Starting Operation
You can even preselect the orbital stroke rate during operation using the necessary orbital stroke rate preselection thumbwheel (6).
1–2 | Low orbital stroke rate |
3–4 | Medium orbital stroke rate |
5–6 | High orbital stroke rate |
The required orbital stroke rate is dependent on the material and the work conditions and can be determined using practical tests.
The Constant Electronic keeps the oscillation speed at no load and under load virtually consistent, guaranteeing uniform performance.
After working at a low orbital stoke rate for an extended period, you should operate the power tool at the maximum orbital stroke rate for approximately three minutes without load to cool it down.
Range of applications | Application | Abrasive | Speed setting | |
---|---|---|---|---|
Sanding plate |
| Coarse sanding | P40–P180 | 4–6 |
Fine sanding | P220–P400 | 1–3 | ||
Sanding plate |
| Coarse sanding | P40–P180 | 4–6 |
Fine sanding | P220–P400 | 1–3 | ||
Sanding plate |
| Coarse sanding | P40–P180 | 4–6 |
Fine sanding | P220–P400 | 1–3 |