Operation with Non-Rechargeable Batteries (Accessory)
To operate with non-rechargeable batteries, alkaline manganese batteries are inserted into the battery adapter.
Note: If you use non-rechargeable batteries other than those recommended, the laser will flash rapidly upon switching on the measuring tool and will then switch itself off.
- The battery adapter is intended only for use in designated Bosch measuring tools and must not be used with power tools.
To insert the non-rechargeable batteries into the battery adapter, push the locking mechanism (19) of the battery adapter cover and lift the cover. Put the non-rechargeable batteries into the battery adapter (18). When inserting the non-rechargeable batteries, ensure that the polarity is correct according to the illustration on the inside of the battery adapter.
Always replace all the batteries at the same time. Only use batteries from the same manufacturer and which have the same capacity.
Close the cover of the battery adapter (18) so that it clicks into place.
To insert the battery adapter, push the battery adapter (18) into the battery bay (22) until you feel it engage.
When operating with non-rechargeable batteries, energy saving mode is switched on as standard. To end energy saving mode, press the button for energy saving mode (1).
To remove the battery adapter (18), press the release button (17) on the battery adapter and pull the battery adapter out of the battery bay (22).
- Take the batteries out of the measuring tool when you are not using it for a prolonged period of time. The batteries can corrode and self-discharge during prolonged storage in the measuring tool.