Starting operation

• Ensure that the GCT 30-42 Auto-Start remote is in the vicinity of the GCA 30-42 receiver.
• Insert the mains plug of the dust extractor into the mains socket.
• Set the switch of the dust extractor to automatic start/stop.
• Insert the plug (4) of the GCA 30-42 receiver (1) into the plug socket on the dust extractor.
• The status indicator with the Auto-Start symbol (2) flashes blue.
• Press the start/stop button (7) on the GCT 30-42 Auto-Start remote until the LED status indicator (6) has flashed blue twice.
  The LED status indicator (6) on the Auto-Start remote GCT 30-42 briefly lights up blue.

Connection established:

• The status indicator with the Auto-Start symbol (2) on the GCA 30-42 receiver lights up green.
• The LED status indicator (6) on the GCA 30-42 Auto-Start remote briefly lights up green.

When changing a coin cell, the following shall apply:

• If the GCT 30-42 transmitter module was connected to the GCA 30-42 receiver module before changing the coin cell, the connection is automatically re-established after changing the coin cell.
• If the modules were not connected before replacing the coin cell, the connection needs to be established.

After a reset, the Auto-Start remote and the receiver must be reconnected.