Starting Operation

Make sure that you are able to press the On/Off switch without releasing the handle.

To switch on the power tool, press the on/off switch (1).

To switch off the power tool, press the on/off switch (1) again.

You can even preselect the orbital stroke rate during operation using the necessary orbital stroke rate preselection thumbwheel (6).

1–2	Low orbital stroke rate
3–4	Medium orbital stroke rate
5–6	High orbital stroke rate

The required orbital stroke rate is dependent on the material and the work conditions and can be determined using practical tests.

The Constant Electronic keeps the oscillation speed at no load and under load virtually consistent, guaranteeing uniform performance.

After working at a low orbital stoke rate for an extended period, you should operate the power tool at the maximum orbital stroke rate for approximately three minutes without load to cool it down.

	Range of applications	Application	Abrasive	Speed setting
Sanding plate 80 x 130 mm	Sanding surfaces and corner spaces Sanding rebates in windows and doors Sanding old paint and varnish Sanding wood Sanding solid wood edges and veneer edges	Coarse sanding	P40–P180	4–6
Sanding plate 80 x 130 mm		Fine sanding	P220–P400	1–3
Sanding plate 100 x 110 mm	Sanding surfaces and corner spaces Sanding rebates in windows and doors Sanding old paint and varnish Sanding wood	Coarse sanding	P40–P180	4–6
Sanding plate 100 x 110 mm		Fine sanding	P220–P400	1–3
Sanding plate 100 x 150 mm	Sanding slats Sanding rebates and profiles Removal from surfaces with angles, corners and edges Sanding old paint and varnish Sanding wood	Coarse sanding	P40–P180	4–6
Sanding plate 100 x 150 mm		Fine sanding	P220–P400	1–3

Starting Operation

Switching On/Off

Preselecting the orbital stroke rate

Application Overview