Starting Operation

  • To switch on the power tool, press the on/off switch (7).
    The user interface lights up.
    GNH 18V-64-2 M GNH 18V-64 MD: If single actuation is activated, the single actuation indicator (31) lights up.
  • To switch off the power tool, press the on/off switch (7).

  • Switch on the power tool.
  • Firmly position the outlet (18) or the rubber workpiece protector (1) on the workpiece until the discharge lock-off (2) is pressed down completely.
    The worklight switches on and the motor starts.
  • Afterwards, briefly press the trigger (6) and release it again.
    This discharges a nail.
  • Allow the power tool to bounce back from the workpiece.
  • For another driving procedure, completely lift the power tool from the workpiece and position it firmly at the next required location.

(GNH 18V-64-2 M, GNH 18V-64 MD)

  • Switch on the power tool.
  • Activate the contact actuation by briefly pressing the mode button (30).
    The contact actuation indicator (32) lights up.
  • Press and hold the trigger (6).
    The worklight switches on and the motor starts.
  • Firmly position the outlet (18) or the rubber workpiece protector (1) on the workpiece until the discharge lock-off (2) is pressed down completely.
    This discharges a nail.
  • For another discharging procedure, keep the trigger (6) pressed and completely lift the power tool from the workpiece. Replace it firmly in the next required position.
  • Switch to single actuation by pressing the mode button (30) again.
    The single actuation indicator (31) lights up.