Inserting the power tool (see figure A)

Ensure that the locking brake (29) is engaged.

Loosen the screw (18) on the drill holder using an open-ended spanner (width across flats 13 mm). Insert the power tool with the collar all the way into the drill holder (19) from above.

Turn the power tool in the drill holder so that all the switches are easy to reach and the dust extraction/water cooling connection on the power tool does not interfere with drilling. Tighten the screw (18) using the open-ended spanner (width across flats 13 mm).

Slide the star handle (17) to the right or left and onto the feed pinion (28) in order to drill.

Check that the power tool is fitted securely in the drill holder.

To remove the power tool from the drill stand, carry out the steps above in reverse order.