Product Features
The numbering of the product features refers to the diagram of the power tool on the graphics page.
(1) | Scale for spacing between saw blade and parallel guide |
(2) | Angle guide |
(3) | Protective cover |
(4) | Riving knife |
(5) | Parallel guide |
(6) | Saw table expansion |
(7) | Angle guide storage compartment |
(8) | Mounting holes |
(9) | Ring spanner (23 mm; 13 mm) |
(10) | Hex key (5 mm) |
(11) | Bracket for storing the protective cover |
(12) | Push stick |
(13) | Clamping handle for saw table expansion |
(14) | Hand wheel |
(15) | Crank for raising and lowering the saw blade |
(16) | On/off switch |
(17) | BatteryA) |
(18) | Stop for 45° bevel angle |
(19) | Scale for bevel angles |
(20) | Locking lever for setting the bevel angle |
(21) | Angle indicator (vertical) |
(22) | Stop for 0° bevel angle |
(23) | Saw table |
(24) | Adjusting screw for adjusting the clamping force of the parallel guide |
(25) | Table insert |
(26) | Saw blade |
(27) | Guide groove for parallel guide |
(28) | Battery release buttonA) |
(29) | Carrying handle |
(30) | Guide groove for angle guide |
(31) | Dust extraction adapter |
(32) | V guide groove on the saw table for the parallel guide |
(33) | Base grid |
(34) | Locking screw for base grid |
(35) | Clamping lever/clamp markings |
(36) | Clamping lever for riving knife |
(37) | Positioning pins for riving knife |
(38) | Table insert locking screw |
(39) | Clamping lever for protective cover |
(40) | Guide pin for protective cover |
(41) | Clamping handle for parallel guide |
(42) | V guide for parallel guide |
(43) | Additional parallel guide |
(44) | "Additional parallel guide" fastening set |
(45) | Guide rail for angle guide |
(46) | Lower saw blade cover |
(47) | Tab for lower saw blade cover |
(48) | Gripping hole for lifting the table insert |
(49) | Clamping nut |
(50) | Spindle locking lever |
(51) | Clamping flange |
(52) | Mounting flange |
(53) | Tool spindle |
(54) | Locking knob for all mitre angles |
(55) | Angle indicator on the angle guide |
(56) | Scale display |
(57) | Saw table spacing indicator |
(58) | Cross-head screw for setting the 0° stop |
(59) | Screw for bevel angle indicator |
(60) | Cross-head screw for setting the 45° stop |
(61) | Hex socket screws (5 mm) on the front for adjusting the parallelism of the saw blade |
(62) | Hex socket screws (5 mm) on the rear for adjusting the parallelism of the saw blade |
(63) | Screw for saw table spacing indicator |
(64) | Hex socket screws (5 mm) for adjusting the parallelism of the parallel guide |
(65) | Screw for parallel guide spacing indicator |
(66) | Adjusting screws for table insert |
(67) | Push stick storage compartment |
(68) | Hex key storage compartment |
(69) | Ring spanner storage compartment |
- A)
Accessories shown or described are not included with the product as standard. You can find the complete selection of accessories in our accessories range.