Extending the saw table

The saw table expansion (11) increases the width of the saw table (17) on the right.

• Pull the clamping handle (18) for the saw table expansion all the way up.
• Pull out the saw table expansion (11) to the required length.
• Push the clamping handle (18) down. This fixes the saw table expansion in place.

The saw table extension (10) increases the length of the saw table (17) to the rear.

• Loosen the locking screw (38) on the left guide rod.
• Pull out the saw table extension (10) to the required length.
• To fix it in position, tighten the locking screw (38).

You may need to support the saw table extension when working with heavy workpieces.

The slide carriage (2) makes it possible to saw workpieces up to a maximum width of 350 mm.
It also ensures greater sawing precision, in particular when used in connection with the angle guide (3) see Sawing mitre angles using the slide carriage.

• Pull the clamping handle (29) for the slide carriage all the way up.
  This makes it possible to move the slide carriage all the way to the front or back.