Transport position and work position of the saw blade

Transport position

• Remove the protective cover (6), remove the table insert (32) and place the riving knife (7) in the bottom position. Reinsert the table insert (32).
• Turn the crank (20) anticlockwise until the teeth of the saw blade (33) lie below the saw table (17).
• Push the saw table expansion (11) in fully.
  Push the clamping handle (18) down. This fixes the saw table expansion in place.

Work position

• Position the riving knife (7) in the top position directly over the centre of the saw blade, insert the table insert (32) and fit the protective cover (6).
• Turn the crank (20) clockwise until the top teeth of the saw blade (33) are approx. 3−6 mm above the workpiece.