Inserting/removing the plastic bag or dust bag (dry vacuuming)

For dry vacuuming, you can insert a plastic bag (19) or a dust bag (accessory) into the container (7). This makes it easier to dispose of coarse dirt.

Open the catches (9) and remove the top part of the vacuum cleaner (10) (see figure C).

Take the pre-filter (22) out of the container (7) by its handle (28).

Insert the plastic bag (19) into the container (7) with the inlet facing upwards. Secure the plastic bag under the suction hole (31) using the clips (32).
Make sure that the plastic bag (19) touches all the inside walls of the container (7).
Fold the rest of the plastic bag (19) over the edge of the container (7).

Insert the pre-filter (22) in the container (7), making sure that the arrow is pointing towards the hose connection piece (3).

Put the top part of the vacuum cleaner (10) on and close the catches (9).

Open the catches (9) and remove the top part of the vacuum cleaner (10) (see figure C).

Take the pre-filter (22) out of the container (7) by its handle (28).

Pull the edge of the full plastic bag (19) backwards out of the clips (32).
Carefully take the plastic bag (19) out of the container (7) without damaging it.
When doing so, make sure that the plastic bag does not scrape against the intake port (31) or other sharp objects.

Open the catches (9) and remove the top part of the vacuum cleaner (10) (see figure C).

Take the pre-filter (22) out of the container (7) by its handle (28).

Pull the full dust bag (19) backwards off the connection flange. Close the opening of the dust bag by folding the lid over. Take the closed dust bag out of the container (7).
Place the new dust bag over the vacuum cleaner's connection flange. Make sure that the entire length of the dust bag touches the inside wall of the container (7).

Insert the pre-filter (22) in the container (7), making sure that the arrow is pointing towards the hose connection piece (3).

Put the top part of the vacuum cleaner (10) on and close the catches (9).