Approved abrasive tools

You can use all the abrasive tools mentioned in these operating instructions.

The permissible speed [min-1] or the circumferential speed [m/s] of the abrasive tools used must at least match the values given in the table.

It is therefore important to observe the permissible rotational/circumferential speed on the label of the abrasive tool.

max. [mm]

[mm]

[°]

 

D

b

s

d

α

[min-1]

[m/s]

180

230

8

8

22.2

22.2

8500

6500

80

80

180

230

4.2

4.2

22.2

22.2

8500

6500

80

80

180

230

8500

6500

80

80

100

125

27

30

M 14

M 14

8500

6500

80

80

180

180

26

20

M 14

22.2

8500

8500

80

80

125

M 14

8500

80

83

M 14

8500

80

180

230

3.0

3.0

7

7

22.2

22.2

> 0

> 0

8500

6500

80

80