Operating Modes

The measuring tool has several operating modes, which you can switch between at any time:

• Cross-line and point mode: The measuring tool generates a horizontal and a vertical laser line as well as two vertical laser points, one facing up, the other down. The laser lines cross at a 90° angle.
• Horizontal line mode: The measuring tool generates a horizontal laser line in front of it.
• Vertical line mode: The measuring tool generates a vertical laser line in front of it.
  Positioning the measuring tool in the room displays the vertical laser line on the ceiling beyond the top laser point.
  If the measuring tool is positioned directly against a wall, the vertical laser line almost encircles the entire space (360° line).
• Point mode: The measuring tool generates two vertical laser points, one facing up, the other down.

To change the operating mode, press the button for laser operating mode (3) as often as required until the laser beams are generated in the required operating mode.

All operating modes can be used with both automatic levelling and the incline function.

All operating modes are suitable for operation with the laser receiver (26).