Changing the Tool
The dust protection cap (3) largely prevents the penetration of drilling dust into the tool holder during operation. When inserting the tool, make sure that the dust protection cap (3) does not become damaged.
- Replace a damaged dust protection cap immediately. It is recommended that you have use an after-sales service for this.
Changing the Tool SDS plus
Inserting the SDS plus Application Tool (see figure B1)
The SDS plus drill chuck (1) enables you to change the application tool easily and conveniently without needing to use additional tools.
- Clean and lightly grease the shank of the application tool.
- Insert the application tool into the tool holder (2) while turning it until it locks automatically.
- Check that it is locked by pulling on the tool.
As a requirement of the system, the SDS plus application tool can move freely. This causes a certain radial run-out at no-load, which has no effect on the accuracy of the drill hole, as the drill bit centres itself upon drilling.
Removing the SDS plus Application Tool (see figure B2)
- Push the locking sleeve (4) back and remove the application tool.