Playing External Audio Sources via AUX (see figure B)

Remove the protective cap of the connector compartment (21) and insert the 3.5‑mm connector of the AUX cable (29) into the AUX socket (14). Connect the AUX cable to a suitable audio source.

Select <AUX> as the audio source. Start and control playback at the audio source.

After removing the AUX cable connector, reattach the protective cap of the connector compartment (21) to protect against dirt/debris.

If one of the preset buttons (6) is pressed during AUX operation, the radio will switch to the station that was saved in the last used radio operating mode.