Starting Operation

You can preselect the required speed using the speed preselection thumbwheel (16), even during operation.

Thumbwheel position

Speed
[min-1]

1−2

10,000−14,000

Low speed

3−4

18,000−24,000

Medium speed

5−6

26,000−30,000

High speed


The values displayed in the following table are guidelines. The required speed depends on the material and the working conditions; it can be ascertained through practical tests.

Material

Router bit diameter [mm]

Thumbwheel position

Hardwood (beech)

4−10
12−20
> 20

5−6
3−4
1−2

Softwood (pine)

4–10
12−20
> 20

5−6
3−6
1−3

Chipboard

4−10
12−20
> 20

3−6
2−4
1−3

Plastics

4−15
> 15

2−3
1−2

After working for a long time at a low speed, you should let the power tool rotate at no load for some time at maximum speed to cool down.

To switch on the power tool, set the on/off switch (13) to I.

To switch off the power tool, set the on/off switch (13) to 0.

The Constant Electronic keeps the speed at no load and under load virtually consistent, guaranteeing uniform performance.