Starting Operation

Pay attention to the mains voltage. The voltage of the power source must match the voltage specified on the rating plate of the power tool.

Products that are only sold in AUS and NZ: Use a residual current device (RCD) with a nominal residual current of 30 mA or less.

Switching On and Off

Make sure that you are able to press the On/Off switch without releasing the handle.

To switch on the power tool, press and hold the on/off switch (5).

To lock the on/off switch (5) press and hold it while also pushing the lock-on button (6).

To switch off the power tool, release the on/off switch (5). If the on/off switch (5) is locked, press the switch first and then release it.