Inserting/removing the disposal bag or safety filter bag (dry extraction) (see figures D1–D3)

Either a disposal bag (27) or safety filter bag (26) must be used for the dry extraction of dust class H materials.

Insofar as materials with or without an exposure limit of ≥ 1 mg/m3 (dust class L materials) are extracted, these can be sucked straight into the container.

WARNING

The dust extractor contains dust particles that pose a risk to health. Emptying and maintenance procedures, including the disposal of dust containers, should only be carried out by professionals. Suitable protective equipment is required. Do not operate the vacuum cleaner unless the complete filter system is correctly inserted. Otherwise, you are putting your health at risk.

  • Open the catches (13) and remove the top part of the vacuum cleaner (12).
  • Insert the disposal bag (27) into the container (1) with the inlet facing forwards.
  • Pull the inlet over the connection flange and all the way into the recess of the connection flange.
  • Make sure that the disposal bag (27) touches all the inside walls of the container (1).
  • Fold the rest of the disposal bag (27) over the edge of the container (1).
  • Put the top part of the vacuum cleaner (12) on and close the catches (13).

  • Seal the container (1) using the sealing plug for extraction connection (2).
  • Open the catches (13) and remove the top part of the vacuum cleaner (12).
  • Pull the full disposal bag (27) backwards out of the connection flange.
  • Seal the disposal bag (27) tightly below the extraction connection opening and the ventilation hole using the cable tie provided.
  • Carefully take the disposal bag (27) out of the container (1) without damaging it.
    When doing so, make sure that the disposal bag does not scrape against the connection flange or other sharp objects.
  • Wipe the container (1) from time to time using a non-abrasive off-the-shelf cleaning product and leave it to dry.

  • Open the catches (13) and remove the top part of the vacuum cleaner (12).
  • Insert the safety filter bag (26) into the container (1) with the inlet facing forwards.
  • Pull the inlet over the connection flange and all the way into the recess of the connection flange.
  • Make sure that the black plastic bag of the safety filter bag (26) touches all the inside walls of the container (1).
  • Make sure that the vacuum compensation hole is in the container.
  • Fold the rest of the black plastic bag over the edge of the container (1).
  • Put the top part of the vacuum cleaner (12) on and close the catches (13).

  • Seal the container (1) using the sealing plug for extraction connection (2).
  • Open the catches (13) and remove the top part of the vacuum cleaner (12).
  • Pull the full safety filter bag (26) backwards out of the connection flange.
  • Seal the opening of the safety filter bag by pushing the closing flap over the opening.
  • Seal the black plastic bag tightly with the cable ties provided.
  • Remove the adhesive label next to the vacuum compensation hole and use it to seal the hole.
  • Carefully take the sealed safety filter bag out of the container (1) without damaging it. When doing so, make sure that the safety filter bag does not scrape against the connection flange or other sharp objects.
  • Wipe the container (1) from time to time using a non-abrasive off-the-shelf cleaning product and leave it to dry.