Fitting the vacuuming accessories (see figure C)

The vacuum hose (25) is equipped with a clip system which can be used to connect vacuuming accessories (dust extraction adapter (23), curved nozzle (24)).

Fitting the dust extraction adapter

• Push the dust extraction adapter (23) onto the vacuum hose (25) until you hear both snap fasteners (35) on the vacuum hose engage.
• To remove the adapter, press the snap fasteners (35) inwards and pull apart the components.

Fitting the nozzles and tubes

• Push the curved nozzle (24) onto the vacuum hose (25) until you hear both snap fasteners (35) on the vacuum hose engage.
• Then attach the required extraction accessory (floor nozzle, crevice nozzle, suction tube, etc.) firmly to the curved nozzle (24).
• To remove the accessory, press the snap fasteners (35) inwards and pull apart the components.