Installing the Saw Stand

• Place the saw stand on the floor with legs up.
• Press the locking pin (15) in and swivel the leg up until the locking pin audibly engages again.
• Repeat this work step with the other three legs.
• Rotate the saw stand into the working position.
• Make sure that the saw stand is stable and all locking pins have engaged.
• A height-adjustable foot (9) helps you to align the saw stand.
• Screw the foot in or out until the saw stand is level and all four legs are on the ground.

• Unscrew the cross-head screw of the roller support (7) with the supplied cross-headed screwdriver (14).
  If required, resist the lock nut on the other side of the roller support with an open-end spanner (10 mm).
• Remove the roller support (7).

There are various options as to how the individual rollers can be arranged on the workpiece support using the internal threaded rod.

• Arrange the individual parts as required and push the internal threaded rod through the rollers and through the workpiece support (1).
• Screw all parts back together.

• Release the locking knobs (3) and pull the table extensions (2) slightly out on both sides of the saw stand.
• Push the workpiece supports (1) from left and right respectively into the upper groove of the saw stand or the table extension.
• The length stops (8) must point outwards here.
• Pull the locking knob (6) to lock the workpiece support.