Operation with Non-Rechargeable Batteries

It is recommended that you use alkaline manganese batteries to operate the measuring tool.

The batteries are inserted into the battery adapter.

The battery adapter is intended only for use in designated Bosch measuring tools and must not be used with power tools.

To insert the batteries, slide the cover (14) of the battery adapter into the battery bay (15). Place the batteries into the cover as per the illustration on the sealing cap (11). Slide the sealing cap over the cover until you feel it click into place.

To remove the batteries (13), press the release buttons (12) on the cap (11) and pull the cap off. Remove the batteries. To remove the cover (14) from inside the battery bay, reach into the cover and pull it out of the measuring tool, applying light pressure to the side wall as you do so.

Always replace all the batteries at the same time. Only use batteries from the same manufacturer and which have the same capacity.

Take the batteries out of the measuring tool when you are not using it for a prolonged period of time. The batteries can corrode during prolonged storage in the measuring tool.