Start-up

Pay attention to the mains voltage. The voltage of the power source must match the voltage specified on the rating plate of the power tool.

Pay attention to the mains voltage! The voltage of the power source must match the voltage specified on the rating plate of the power tool. Power tools marked with 230 V can also be operated with 220 V.

Always tighten the locking knob (16) and the clamping wheel (45) firmly before sawing. Otherwise the saw blade can become wedged in the workpiece.

Switching on (see figure M)

To switch on the power tool, first slide the lock-off button (5) to the middle and then press and hold the on/off switch (6).

Note: For safety reasons, the on/off switch (6) cannot be locked; it must remain pressed during the entire operation.

Switching off

To switch off, release the on/off switch (6).