Technical data
Angle Grinder | GWS 20-230 P | GWS 20-230 J | |
|---|---|---|---|
Article number | 3 601 HC1 1.. | 3 601 HC1 3.. | |
Rated power input | W | 2000 | 2000 |
Rated speed | min–1 | 6500 | 6500 |
Max. grinding disc diameter | mm | 230 | 230 |
Grinding spindle thread | M 14 | M 14 | |
Max. thread length of grinding spindle | mm | 25 | 25 |
Restart protection | – | ● | |
Starting current limitation | – | ● | |
Weight according to EPTA-Procedure 01/2014 | |||
| kg | 5.5 | 5.5 |
| kg | 5.4 | 5.4 |
Protection class |
|
| |
/ IIThe specifications apply to a rated voltage [U] of 230 V. These specifications may vary at different voltages and in country-specific models.
Notes on mains connection requirements for GWS 20-230 P:
The appliance meets IEC 61000-3-11 requirements and is subject to conditional connection. The appliance can lead to occasional voltage fluctuations under unfavorable power conditions. The impedance of this appliance is set as Zactual = 0.18 Ω. The user must make sure, that the connection point, with the impedance Zmax, on which the appliance shall be plugged in meets the impedance requirement: Zactual ≥ Zmax. If Zmax is unknown, determine Zmax in consultation with the network supplier or supply authority.
Angle Grinder | GWS 22-230 P | GWS 22-180 J | GWS 22-230 J | |
|---|---|---|---|---|
Article number | 3 601 HC1 1.. | 3 601 HC0 3.. | 3 601 HC1 3.. | |
Rated power input | W | 2200 | 2200 | 2200 |
Rated speed | min–1 | 6500 | 8500 | 6500 |
Max. grinding disc diameter | mm | 230 | 180 | 230 |
Grinding spindle thread | M 14 | M 14 | M 14 | |
Max. thread length of grinding spindle | mm | 25 | 25 | 25 |
Restart protection | – | ● | ● | |
Starting current limitation | – | ● | ● | |
Weight according to EPTA-Procedure 01/2014 | ||||
| kg | 5.5 | 5.3 | 5.5 |
| kg | 5.4 | 5.2 | 5.4 |
Protection class |
|
|
| |
The specifications apply to a rated voltage [U] of 230 V. These specifications may vary at different voltages and in country-specific models.
Notes on mains connection requirements for GWS 22-230 P:
The appliance meets IEC 61000-3-11 requirements and is subject to conditional connection. The appliance can lead to occasional voltage fluctuations under unfavorable power conditions. The impedance of this appliance is set as Zactual = 0.18 Ω. The user must make sure, that the connection point, with the impedance Zmax, on which the appliance shall be plugged in meets the impedance requirement: Zactual ≥ Zmax. If Zmax is unknown, determine Zmax in consultation with the network supplier or supply authority.