Operating modes

Remove the battery from the power tool before carrying out work on the power tool (e.g. maintenance, changing tool, etc.). The battery should also be removed for transport and storage. There is risk of injury from unintentionally pressing the on/off switch.

Pendulum action settings

The pendulum action can be adjusted using four different settings, allowing the cutting speed, cutting capacity and the cut itself to be optimally adapted to the material that you want to cut.

You can also adjust the pendulum action during operation using the adjusting lever (22).

Level 0	No pendulum action
Level I	Low pendulum action
Level II	Moderate pendulum action
Level III (MAX)	High pendulum action

The optimum pendulum level for each application can be determined by a practical test. Note the following recommendations:

Select a lower pendulum level or switch off the pendulum action completely if you wish to produce a finer or cleaner cutting edge.
Switch off the pendulum action when machining thin materials (e.g. sheets).
Work on hard materials (e.g. steel) with low pendulum action.
You can work on soft materials and saw wood using maximum pendulum action.

Sawdust blower device

The cutting line can be kept clear of chips using the airflow from the sawdust blower device.

To switch on the sawdust blower device: When working with high material removal in wood, plastic and other similar materials, push the switch (23) to the I position.

To switch off the sawdust blower device: When working in metal and with a dust extraction system connected, push the switch (23) to the 0 position.