Intended Use

The saw stand is intended for holding the following Bosch benchtop saws (stand 2024.06):

• GCM 8 S (3 601 L16 0..)
• GCM 8 SJ (3 601 L16 2..)
• GCM 800 S (3 601 L16 1..)
• GCM 80 SJ (3 601 M19 0..)
• GCM 800 SJ (3 601 M19 0..)
• GCM 8 SJL (3 601 M19 1..)
• GCM 8 SDE (3 601 M19 2..)
  
• GCM 10 (0 601 B20 0..)
• GCM 10 J/GCM 10 M (3 601 M20 2..)
• GCM 10 S (0 601 B20 5..)
• GCM 10 SD (0 601 B22 5..)
• GCM 10 GDJ (3 601 M27 0..)
  
• GCM 12 (0 601 B21 0..)
• GCM 12 SD (0 601 B23 5..)
• GCM 12 SDE (3 601 M23 1..)
• GCM 12 GDL (3 601 M23 6..)
  
• GCM 350-216 (3 601 M49 0..)
• GCM 350-254 (3 601 M22 6..)
  
• GCM 18V-216 D (3 601 M51 0..)
• GCM 18V-216 DC (3 601 M47 0..)
• GCM 18V-254 D (3 601 M51 1..)
• GCM 18V-305 GDC (3 601 M43 0..)
  
• GTM 12 (3 601 M15 0..)
• GTM 12 JL (3 601 M15 0..)

The saw stand and power tool are intended for cutting boards and profiles.