Approved abrasive tools
You can use all the abrasive tools mentioned in these operating instructions.
The permissible speed [min-1] or the circumferential speed [m/s] of the abrasive tools used must at least match the values given in the table.
It is therefore important to observe the permissible rotational/circumferential speed on the label of the abrasive tool.
Max. [mm] | [mm] | [°] |
|
| |||
|---|---|---|---|---|---|---|---|
| D | b | s | d | α | [min-1] | [m/s] |
| 125 | 7.2 | – | X-LOCK | – – | 11500 | 80 |
| 125 | 4.2 | – | X-LOCK | – | 11500 | 80 |
| 125 | – | – | X-LOCK | – | 11500 | 80 |
| 75 | 30 | – | X-LOCK | – | 11500 | 80 |
| 125
| 19
| –
| X-LOCK | –
| 11500
| 80
|
| 125 | – | – | X-LOCK | – | 11500 | 80 |
| 83 | – | – | X-LOCK | – | 11500 | 80 |
| 125 | 6 | 10 | X-LOCK | > 0 | 11500 | 80 |
